უსაფრთხო გადახდა
Features:
Specifications:
Model | DS04254C |
Bandwidth | 250MHz |
Horizontal | |
Sample Rate Range | 1GS/S |
Waveform Interpolation | (sin x)/x |
Record Length | Maximum 64K samples per single-channel; |
Maximum 32K samples per dual-channel (4K, 32K optional) | |
SEC/DIV Range | 2ns/div~100s/div |
1.2,5 suite | |
Sample Rate and | ±50ppm |
Delay Time Accuracy | Single-shot, Normal mode |
Deltas Time | ± (1 sample interval +100ppm x reading + 0.6ns) |
Measurement Accuracy | >16 averages |
(Full Bandwidth) | ± (1 sample interval +100ppm x reading + 0.4ns) |
Sample interval = s/div + 200 | |
Vertical | |
AD converter | 8-bit resolution,each channel sampled simultaneously |
VOLTS/DIV Range | 500pV/div to 10V/div at input BNC |
Position Range | 500pV/div-20mV/div. ±400mV |
50mV/dlv-200mV/div. ±2V | |
500mV/div-2V/div. ±40V | |
5V/dlv-10V/div. ±50V | |
Selectable Analog Bandwidth Limit typical | 20MHz |
Low Frequency Response (-3db) | u2264 10HZ at BNC |
Rise Time at BNC. typical | <l.4ns |
DC Gain Accuracy | ±3% for Normal or Average acquisition mode. 10V/divto 10mV/dlv |
±4% for Normal or Average acquisition mode, 5mV/div to 500pV/div | |
Note: Bandwidth reduced to 6MHzwhen using a 1X probe. | |
Acquisition | |
Acquisition Modes | Normal. Peak Detect Average and HR |
Acquisition Rate, typical | Up to 2000 waveforms per second per channel (Normal acquisition mode, no measurement) |
Single Suite | Acquisition Mode |
Normal. Peak Detect | |
Average | |
Trigger |
Mode | Auto. Normal |
Level | CH1-CH4 |
EXT | |
Holdoff Range | 20ns~10s |
Trigger Level | CH1-CH4 |
Accuracy | EXT |
Edge Trigger | |
Slope | Rising, Falling. Rising&Falling |
Source | CH1-CH4/EXT |
Pulse Width | |
Polarity | Positive. Negative |
Condition(When) | <,>,!=,= |
Source | CH1~CH4 |
Width Range | 8ns ~10s |
Resolution | 8ns |
Video Trigger | |
Signal Standard | NTSC. PAL |
Source | CH1-CH4 |
Sync | ScanLine. LinrNum. OddField, EvenField and AllField |
Slope Trigger | |
Slope | Rising, Falling |
Condition(When) | <,>.!=.= |
Source | CH1 - CH4 |
Time Range | 8ns " 10s |
Resolution | 8ns |
Overtime Trigger | |
Source | CH1-CH4 |
Polarity | Positive. Negative |
Time Range | 8ns ~10s |
Resolution | 8ns |
Window Trigger | |
Source | CH1-CH4 |
Pattern Trigger | |
Pattern | 0: Lower level; 1: High level; |
Level | CH1-CH4 |
Interval Trigger | |
Slope | Rising. Falling |
Condition(When) | <>.!=.= |
Source | CH1-CH4 |
Time Range | 8ns-10s |
Resolution | 8ns |
Under Amp | |
Polarity | Positive. Negative |
Condition(When) | <,>!=,= |
Source | CH1-CH4 |
Time Range | 8ns- 10s |
Resolution | 8ns |
UART Trigger | |
Condition(When) | Start, Stop, Data. Parity Error. COM Error |
Source(RX/TX) | CH1-CH4 |
Data format | Hex |
Condition(When) | <,>!=,= |
Data Length | 1 byte |
Data Length | 5 bit 6 bit 7 bit 8 bit |
Parity Check | None, Odd, Even |
idle Level | High. Low |
Baud | 110/300/600/1200/2400/4800/9600/14400/19200/38400/57600/115200/230400/380400/460400 |
Rate(Selectable) | bit/s |
Baud Rate (Custom) | 300biVs-334000bit/s |
UN Trigger | |
Condition(When) | Interval Field, Sync Field, Id field, Sync Id Error, Identifier, Id, Data |
Source | CH1-CH4 |
Data format | Hex |
Baud Rate | 110/300/600/1200/2400/4800/9600/14400/19200/38400/57600/115200/230400/380400/460400 |
(Selectable) | bit/s |
Baud Rate (Custom) | 300bit/s-334000biVs |
CAN Trigger | |
Condition(When) | Condition(When) Start Bit Remote Frame. Data Frame Id. Frame Id. Data Frame Id, Error Frame. All Error. Ack Error. Overload Fram |
Source | CH1-CH4 |
Data format | Hex |
Baud Rate | 10000. 20000. 33300. 500000. 62500. 83300.100000.125000. 250000. 500000. 800000. |
(Selectable) | 1000000 |
Baud Rate (Custom) | 5kbit/s-1Mbi/s |
SPI Trigger |
Source(CS/CLK/Data) | CH1-CH4 |
Data format | Hex |
Data Length | 4,8, 16,24,32 |
IIC Trigger | |
Source (SDA/SCL) | CH1-CH4 |
Data format | Hex |
Data Index | 0-7 |
When(Condition) | Start. Stop. No Ack, Address. Data. Restart |
Inputs | |
Input Couplinq | DC, AC or GND |
Input Impedance. DC coupled | 20pF±3pF, 1MO±2% |
Probe Attenuation | 1X, 10X |
Supported Probe Attenuation Factors | 1X, 10X,100X,1000X |
Over voltage Category | 300V CAT II |
Maximum Input Voltage | 300V RMS(10X) |
Measurements | |
Cursors | Voltage difference between cursors: AV |
Time difference between cursors: AT | |
Reciprocal of/T in Hertz(1/ T) | |
Automatic Measurements | Frequency. Period. Average. Pk-Pk. RMS, PeriodRms. Min. Max, RiseTime, FallTime. + Width.-Width. + Duty. - Duty. Vbase, Vtop. Vmid. Vamp. Overshoot. Preshoot. PeriodAvg, FOVShoot. RPREShoot BWidth, FRR. FFF. FRF. FFR. LRR. LRF. LFR and LFF |
General Specifications | |
Display | |
Display Type | 7 inch 64K color TFT (diagonal liquid crystal) |
Display Resolution | 800 horizontal by 480 vertical pixels |
Display Contrast | Adjustable |
Probe Compensator Output | |
Output Voltage, typical | About 2Vpp into ≥1Mu03a9 load |
Frequency, typical | 1kHz |
Power Supply | |
Supply Voltage | 100-120VACRMS(±10%).45Hz to 440Hz, CATII 120-240VACRMS(±10%).45Hz to 66Hz, CATII |
Power Consumption | <30W |
Fuse | T, 3.15A, 250V, 5x20mm |
Environmental | |
Operating Temperature | 0-50°(32-122 °) |
Storage Temperature | -40~+71° (-40~159.8 °) |
Humidity | u2264+104°(u2264+40°): u226490% relative humidity |
106°~122°F (+41° ~50°): u226460% relative humidity | |
Cooling Method | Convection |
Altitude | Operating and Nonoperating |
Mechanical Shock | Operating |
Arbitrary Waveform Generator Mode | |
Waveform Frequency | Sine: 0.1HZ-25MHZ |
Square: 0.1Hz~10MHz | |
Ramp: 0.1HZ-1MHZ | |
EXP: 0.1HZ"5MHz | |
Amplitude | 5mV-3.5Vp-p(50u03a9) 10mV-7Vp-p(High impedance) |
DAC | 2K~200MHz adjustable |
Frequency Resolution | 0.001 |
Channel | 1CH waveform output |
Waveform Depth | 4KSa |
Vertical Resolution | 12 bit |
Frequency Stability | <30ppm |
Output Impedance | 50u03a9 |
Package included:
1 x DSO4254C Oscilloscope
4 x Probe
1 x USB cable
1 x Power cable
1 x CD
მიიღეთ უახლესი ამბები და 15% ფასდაკლება თქვენს პირველ შეკვეთაზე.